Helfer fuer Klempner und Rohrleitungsbauer

Bau, Wartung und Reparatur

KI-Exposition

  • Datenquelle: BLSVeröffentlicht: 2026-08

    Niedrig· relativ

    NiedrigVier relative BänderSehr hoch

    Wert auf Berufsgruppenebene

    Skala, Bezugsmenge und Quelle

    Vier relative Bänder (Niedrig / Mittel / Hoch / Sehr hoch)

    831 detaillierte Berufe in der BLS-Beschäftigungsprojektionstabelle. Der Wert wird je Code der National Employment Matrix (NEM) vergeben, daher erhalten Berufe mit demselben NEM-Code dasselbe Band

    Quelldatensatz (XLSX-Download)

  • Datenquelle: AnthropicVeröffentlicht: 2026-03

    0.000

    0.000Spannweite der hier geführten Werte0.745
    Skala, Bezugsmenge und Quelle

    Index der beobachteten Exposition, 0–1 wie veröffentlicht

    Auf O*NET-Aufgaben abgebildet

    Quelldatensatz

  • Datenquelle: ILOVeröffentlicht: 2025

    0.09

    0.09Spannweite der hier geführten Werte0.70

    Wert auf Berufsgruppenebene

    Skala, Bezugsmenge und Quelle

    Index der Exposition gegenüber generativer KI, 0–1 wie veröffentlicht

    ISCO-08-Berufsgattung — alle Berufe mit demselben Code erhalten diesen Wert

    Von dieser Website berechnet, nicht von der IAO veröffentlicht: Von den 1.012 Berufen, die diese Website mit dem IAO-Datensatz verknüpft, erreichen oder übertreffen 100% diesen Wert.

    Quelldatensatz

Welche Art von Wert diese Quelle veröffentlicht

Die Kategorie von BLS ist ein relativer Rang und kein absolutes Niveau, und sie ist keine eigene Messung: Sie fasst die Perzentilränge des Berufs aus mehreren veröffentlichten Studien in vier Bänder zusammen. Sie ist weder eine Beschäftigungs- oder Lohnprognose noch eine Einführungswahrscheinlichkeit und unterscheidet nicht zwischen Automatisierung und Augmentierung.

Task-level exposure

Values in this tab are predicted labels, not observations. Eloundou et al. (2023) published two rating regimes — human raters and GPT-4 — and the β shown here is derived from the GPT-4 rater basis alone; the same task can take a different value under the other regime. The unit and the meaning differ from the observed shares (%) in the other tabs, so do not place them on the same axis.

TaskβE1 + 0.5 × E2
Cut or drill holes in walls or floors to accommodate the passage of pipes.

O*NET Task ID 4857

0.0
Measure, cut, thread and assemble new pipe, placing the assembled pipe in hangers or other supports.

O*NET Task ID 4858

0.0
Mount brackets and hangers on walls and ceilings to hold pipes, and set sleeves or inserts to provide support for pipes.

O*NET Task ID 4859

0.0
Requisition tools and equipment, select type and size of pipe, and collect and transport materials and equipment to work site.

O*NET Task ID 4860

0.0
Fit or assist in fitting valves, couplings, or assemblies to tanks, pumps, or systems, using hand tools.

O*NET Task ID 4861

0.0
Assist pipe fitters in the layout, assembly, and installation of piping for air, ammonia, gas, and water systems.

O*NET Task ID 4862

0.0
Excavate and grade ditches, and lay and join pipe for water and sewer service.

O*NET Task ID 4863

0.0
Cut pipe and lift up to fitters.

O*NET Task ID 4864

0.0
Disassemble and remove damaged or worn pipe.

O*NET Task ID 4865

0.0
Clean shop, work area, and machines, using solvent and rags.

O*NET Task ID 4866

0.0
Install gas burners to convert furnaces from wood, coal, or oil.

O*NET Task ID 4867

0.0
Immerse pipe in chemical solution to remove dirt, oil, and scale.

O*NET Task ID 4868

0.0
Clean and renew steam traps.

O*NET Task ID 4869

0.0
Fill pipes with sand or resin to prevent distortion, and hold pipes during bending and installation.

O*NET Task ID 4870

0.0
Perform rough-ins, repair and replace fixtures and water heaters, and locate, repair, or remove leaking or broken pipes.

O*NET Task ID 20144

0.0

β = E1 + 0.5 × E2 · E1 = tasks where direct LLM access alone cuts time by at least 50%, E2 = tasks where software built on top of an LLM cuts time by at least 50%. Values take only 0 / 0.5 / 1.0.

Data sources & licenses — O*NET®, Eloundou et al. (2023): see full notices on the Credits page

Berufsinformationen