Poseurs de sols
Construction, Maintenance et RéparationExposition à l'IA
- Source des données: BLSPublié: 2026-08
Faible· relative
FaibleQuatre bandes relativesTrès élevéeValeur par groupe professionnel
Échelle, base et source
Quatre bandes relatives (Faible / Modérée / Élevée / Très élevée)
831 métiers détaillés du tableau des projections d'emploi du BLS. La valeur est attribuée par code de la National Employment Matrix (NEM), si bien que les métiers partageant un code NEM reçoivent la même bande
- Source des données: AnthropicPublié: 2026-03
0.000
0.000Étendue des valeurs présentées ici0.745Échelle, base et source
- Source des données: ILOPublié: 2025
0.10
0.09Étendue des valeurs présentées ici0.70Valeur par groupe professionnel
Échelle, base et source
Indice d'exposition à l'IA générative, 0–1 tel que publié
Groupe de base CITP-08 — tous les métiers partageant le code reçoivent cette valeur
Calculé par ce site, non publié par l'OIT : sur les 1 012 professions que ce site relie au jeu de données de l'OIT, 98% atteignent ou dépassent cette valeur.
Quelle est la nature de la valeur publiée par cette source
La catégorie BLS est un rang relatif et non un niveau absolu, et ce n'est pas une mesure de première main : elle regroupe en quatre bandes les rangs centiles du métier dans plusieurs études publiées. Ce n'est ni une prévision d'emploi ou de salaire, ni une probabilité d'adoption, et elle ne distingue pas automatisation et augmentation.
Task-level exposure
Values in this tab are predicted labels, not observations. Eloundou et al. (2023) published two rating regimes — human raters and GPT-4 — and the β shown here is derived from the GPT-4 rater basis alone; the same task can take a different value under the other regime.
| Task | βE1 + 0.5 × E2 |
|---|---|
Sweep, scrape, sand, or chip dirt and irregularities to clean base surfaces, correcting imperfections that may show through the covering.O*NET Task ID 8253 | 0.0 |
Cut flooring material to fit around obstructions.O*NET Task ID 8254 | 0.0 |
Inspect surface to be covered to ensure that it is firm and dry.O*NET Task ID 8255 | 0.0 |
Trim excess covering materials, tack edges, and join sections of covering material to form tight joint.O*NET Task ID 8256 | 0.0 |
Form a smooth foundation by stapling plywood or Masonite over the floor or by brushing waterproof compound onto surface and filling cracks with plaster, putty, or grout to seal pores.O*NET Task ID 8257 | 0.0 |
Measure and mark guidelines on surfaces or foundations, using chalk lines and dividers.O*NET Task ID 8258 | 0.0 |
Cut covering and foundation materials, according to blueprints and sketches.O*NET Task ID 8259 | 0.0 |
Roll and press sheet wall and floor covering into cement base to smooth and finish surface, using hand roller.O*NET Task ID 8260 | 0.0 |
Apply adhesive cement to floor or wall material to join and adhere foundation material.O*NET Task ID 8261 | 0.0 |
Determine traffic areas and decide location of seams.O*NET Task ID 8262 | 0.0 |
Lay out, position, and apply shock-absorbing, sound-deadening, or decorative coverings to floors, walls, and cabinets, following guidelines to keep courses straight and create designs.O*NET Task ID 8263 | 0.0 |
Remove excess cement to clean finished surface.O*NET Task ID 8264 | 0.0 |
Disconnect and remove appliances, light fixtures, and worn floor and wall covering from floors, walls, and cabinets.O*NET Task ID 8265 | 0.0 |
Heat and soften floor covering materials to patch cracks or fit floor coverings around irregular surfaces, using blowtorch.O*NET Task ID 8266 | 0.0 |
β = E1 + 0.5 × E2 · E1 = tasks where direct LLM access alone cuts time by at least 50%, E2 = tasks where software built on top of an LLM cuts time by at least 50%. Values take only 0 / 0.5 / 1.0.
Data sources & licenses — O*NET®, Eloundou et al. (2023): see full notices on the Credits page