عمال تعليق ورق الجدران

البناء والصيانة والإصلاح

التعرّض للذكاء الاصطناعي

  • مصدر البيانات: BLSتاريخ النشر: 2026-08

    منخفض· نسبي

    منخفضأربع فئات نسبيةمرتفع جدًا

    قيمة على مستوى المجموعة المهنية

    المقياس والأساس والمصدر

    أربع فئات نسبية (منخفض / متوسط / مرتفع / مرتفع جدًا)

    831 مهنة تفصيلية في جدول توقعات التوظيف لدى BLS. وتُسند القيمة على مستوى رمز مصفوفة التوظيف الوطنية (NEM)، فالمهن التي تشترك في الرمز نفسه تأخذ النطاق نفسه

    مجموعة البيانات المصدر (تنزيل ملف XLSX)

  • مصدر البيانات: Anthropicتاريخ النشر: 2026-03

    0.000

    0.000نطاق القيم المعروضة هنا0.745
    المقياس والأساس والمصدر

    مؤشر التعرّض المرصود، 0–1 كما نُشر

    مربوط بمهام O*NET

    مجموعة البيانات المصدر

  • مصدر البيانات: ILOتاريخ النشر: 2025

    0.13

    0.09نطاق القيم المعروضة هنا0.70

    قيمة على مستوى المجموعة المهنية

    المقياس والأساس والمصدر

    مؤشر التعرّض للذكاء الاصطناعي التوليدي، 0–1 كما نُشر

    وحدة التصنيف ISCO-08 — تأخذ كل المهن ذات الرمز نفسه هذه القيمة

    محسوب من قِبل هذا الموقع وليس منشورًا من منظمة العمل الدولية: من بين 1,012 مهنة يربطها هذا الموقع بمجموعة بيانات المنظمة، تبلغ نسبة التي تساوي هذه القيمة أو تتجاوزها 97%.

    مجموعة البيانات المصدر

ما نوع القيمة التي ينشرها هذا المصدر

فئة BLS رتبة نسبية لا مستوى مطلق، وليست قياسًا مباشرًا: فهي تجمع الرتب المئينية للمهنة في عدة دراسات منشورة في أربع فئات. وهي ليست توقّعًا للتوظيف أو الأجور، ولا احتمالًا للتبني، ولا تفرّق بين الأتمتة والتعزيز.

TaskAPIRaw / share %
Measure surfaces or review work orders to estimate the quantities of materials needed.

47-2142

0.0015100.0
Not observed on any surface — 19 task(s) — These tasks have no row in the source for this release. The 0 in the share row is a display-stage composition ratio; absence is what the — in the raw row states.
Smooth strips or sections of paper with brushes or rollers to remove wrinkles and bubbles and to smooth joints.
—0
Trim rough edges from strips, using straightedges and trimming knives.
—0
Trim excess material at ceilings or baseboards, using knives.
—0
Check finished wallcoverings for proper alignment, pattern matching, and neatness of seams.
—0
Mark vertical guidelines on walls to align strips, using plumb bobs and chalk lines.
—0
Cover interior walls and ceilings of rooms with decorative wallpaper or fabric, using hand tools.
—0
Apply adhesives to the backs of paper strips, using brushes, or dunk strips of prepasted wallcovering in water, wiping off any excess adhesive.
—0
Measure and cut strips from rolls of wallpaper or fabric, using shears or razors.
—0
Place strips or sections of paper on surfaces, aligning section edges and patterns.
—0
Fill holes, cracks, and other surface imperfections preparatory to covering surfaces.
—0
Apply sizing to seal surfaces and maximize adhesion of coverings to surfaces.
—0
Smooth rough spots on walls and ceilings, using sandpaper.
—0
Set up equipment, such as pasteboards and scaffolds.
—0
Remove old paper, using water, steam machines, or solvents and scrapers.
—0
Apply thinned glue to waterproof porous surfaces, using brushes, rollers, or pasting machines.
—0
Mix paste, using paste powder and water, and brush paste onto surfaces.
—0
Staple or tack advertising posters onto fences, walls, billboards, or poles.
—0
Remove paint, varnish, dirt, and grease from surfaces, using paint remover and water soda solutions.
—0
Apply acetic acid to damp plaster to prevent lime from bleeding through paper.
—0

Data sources & licenses — O*NET®, Anthropic Economic Index, Eloundou et al. (2023): see full notices on the Credits page

معلومات مهنية