মেঝে স্থাপনকারী
নির্মাণ, রক্ষণাবেক্ষণ ও মেরামতAI এক্সপোজার
- ডেটার উৎস: BLSপ্রকাশকাল: 2026-08
কম· আপেক্ষিক
কমচারটি আপেক্ষিক স্তরঅত্যন্ত উচ্চপেশা-গোষ্ঠী পর্যায়ের মান
স্কেল, ভিত্তি ও উৎস
চারটি আপেক্ষিক স্তর (কম / মাঝারি / উচ্চ / অত্যন্ত উচ্চ)
BLS কর্মসংস্থান পূর্বাভাস সারণির 831টি বিস্তারিত পেশার ভিত্তিতে। মান NEM (ন্যাশনাল এমপ্লয়মেন্ট ম্যাট্রিক্স) কোড অনুযায়ী দেওয়া হয়, তাই একই NEM কোডের পেশাগুলি একই ব্যান্ড পায়
- ডেটার উৎস: Anthropicপ্রকাশকাল: 2026-03
0.000
0.000এখানে থাকা মানগুলোর পরিসর0.745স্কেল, ভিত্তি ও উৎস
- ডেটার উৎস: ILOপ্রকাশকাল: 2025
0.10
0.09এখানে থাকা মানগুলোর পরিসর0.70পেশা-গোষ্ঠী পর্যায়ের মান
স্কেল, ভিত্তি ও উৎস
জেনারেটিভ AI এক্সপোজার সূচক, প্রকাশিত রূপে 0–1
ISCO-08 ইউনিট গ্রুপ — একই কোডের সব পেশা এই মানই পায়
এটি এই সাইটের হিসাব, ILO-এর প্রকাশিত সংখ্যা নয়: এই সাইট ILO ডেটাসেটের সঙ্গে যুক্ত করা ১,০১২টি পেশার মধ্যে 98% এই মানের সমান বা তার বেশি।
এই উৎস কী ধরনের মান প্রকাশ করে
BLS-এর শ্রেণিবিভাগ একটি আপেক্ষিক র্যাঙ্ক, পরম মাত্রা নয়, এবং এটি সরাসরি পরিমাপও নয়: এটি কয়েকটি প্রকাশিত গবেষণায় পাওয়া পেশার পার্সেন্টাইল র্যাঙ্কগুলিকে চারটি স্তরে ভাগ করে। এটি কর্মসংস্থান বা মজুরির পূর্বাভাস নয়, গ্রহণের সম্ভাবনাও নয়, এবং এটি স্বয়ংক্রিয়তা ও সম্প্রসারণের মধ্যে পার্থক্য করে না।
Task-level exposure
Values in this tab are predicted labels, not observations. Eloundou et al. (2023) published two rating regimes — human raters and GPT-4 — and the β shown here is derived from the GPT-4 rater basis alone; the same task can take a different value under the other regime.
| Task | βE1 + 0.5 × E2 |
|---|---|
Sweep, scrape, sand, or chip dirt and irregularities to clean base surfaces, correcting imperfections that may show through the covering.O*NET Task ID 8253 | 0.0 |
Cut flooring material to fit around obstructions.O*NET Task ID 8254 | 0.0 |
Inspect surface to be covered to ensure that it is firm and dry.O*NET Task ID 8255 | 0.0 |
Trim excess covering materials, tack edges, and join sections of covering material to form tight joint.O*NET Task ID 8256 | 0.0 |
Form a smooth foundation by stapling plywood or Masonite over the floor or by brushing waterproof compound onto surface and filling cracks with plaster, putty, or grout to seal pores.O*NET Task ID 8257 | 0.0 |
Measure and mark guidelines on surfaces or foundations, using chalk lines and dividers.O*NET Task ID 8258 | 0.0 |
Cut covering and foundation materials, according to blueprints and sketches.O*NET Task ID 8259 | 0.0 |
Roll and press sheet wall and floor covering into cement base to smooth and finish surface, using hand roller.O*NET Task ID 8260 | 0.0 |
Apply adhesive cement to floor or wall material to join and adhere foundation material.O*NET Task ID 8261 | 0.0 |
Determine traffic areas and decide location of seams.O*NET Task ID 8262 | 0.0 |
Lay out, position, and apply shock-absorbing, sound-deadening, or decorative coverings to floors, walls, and cabinets, following guidelines to keep courses straight and create designs.O*NET Task ID 8263 | 0.0 |
Remove excess cement to clean finished surface.O*NET Task ID 8264 | 0.0 |
Disconnect and remove appliances, light fixtures, and worn floor and wall covering from floors, walls, and cabinets.O*NET Task ID 8265 | 0.0 |
Heat and soften floor covering materials to patch cracks or fit floor coverings around irregular surfaces, using blowtorch.O*NET Task ID 8266 | 0.0 |
β = E1 + 0.5 × E2 · E1 = tasks where direct LLM access alone cuts time by at least 50%, E2 = tasks where software built on top of an LLM cuts time by at least 50%. Values take only 0 / 0.5 / 1.0.
Data sources & licenses — O*NET®, Eloundou et al. (2023): see full notices on the Credits page