Albañiles
Construcción, Mantenimiento y ReparaciónExposición a la IA
- Fuente de datos: BLSPublicado: 2026-08
Bajo· relativa
BajoCuatro bandas relativasMuy altoValor por grupo ocupacional
Escala, base y fuente
Cuatro bandas relativas (Bajo / Moderado / Alto / Muy alto)
831 ocupaciones detalladas de la tabla de proyecciones de empleo de BLS. El valor se asigna por código de la National Employment Matrix (NEM), de modo que las ocupaciones que comparten un código NEM reciben la misma banda
- Fuente de datos: AnthropicPublicado: 2026-03
0.000
0.000Rango de los valores aquí recogidos0.745Escala, base y fuente
Índice de exposición observada, 0–1 tal como se publica
Mapeado sobre tareas de O*NET
- Fuente de datos: ILOPublicado: 2025
0.09
0.09Rango de los valores aquí recogidos0.70Valor por grupo ocupacional
Escala, base y fuente
Índice de exposición a la IA generativa, 0–1 tal como se publica
Grupo primario de la CIUO-08 — todas las ocupaciones con ese código reciben este valor
Calculado por este sitio, no publicado por la OIT: de las 1012 ocupaciones que este sitio vincula al conjunto de datos de la OIT, un 100% alcanza o supera este valor.
Qué tipo de cifra publica esta fuente
La categoría de BLS es un rango relativo, no un nivel absoluto, y tampoco es una medición de primera mano: agrupa en cuatro bandas los rangos percentiles de la ocupación en varios estudios publicados. No es una previsión de empleo ni de salarios, no es una probabilidad de adopción y no distingue entre automatización y aumento.
Task-level exposure
Solo tareas expuestas| Task | APIRaw / share % |
|---|---|
Interpret blueprints and drawings to determine specifications and to calculate the materials required.47-2021 | 0.0017100.0 |
| Not observed on any surface — 13 task(s) — These tasks have no row in the source for this release. The 0 in the share row is a display-stage composition ratio; absence is what the — in the raw row states. | |
Construct corners by fastening in plumb position a corner pole or building a corner pyramid of bricks, and filling in between the corners using a line from corner to corner to guide each course, or layer, of brick. | —0 |
Measure distance from reference points and mark guidelines to lay out work, using plumb bobs and levels. | —0 |
Calculate angles and courses and determine vertical and horizontal alignment of courses. | —0 |
Fasten or fuse brick or other building material to structure with wire clamps, anchor holes, torch, or cement. | —0 |
Break or cut bricks, tiles, or blocks to size, using trowel edge, hammer, or power saw. | —0 |
Remove excess mortar with trowels and hand tools, and finish mortar joints with jointing tools, for a sealed, uniform appearance. | —0 |
Apply and smooth mortar or other mixture over work surface. | —0 |
Mix specified amounts of sand, clay, dirt, or mortar powder with water to form refractory mixtures. | —0 |
Examine brickwork or structure to determine need for repair. | —0 |
Clean working surface to remove scale, dust, soot, or chips of brick and mortar, using broom, wire brush, or scraper. | —0 |
Lay and align bricks, blocks, or tiles to build or repair structures or high temperature equipment, such as cupola, kilns, ovens, or furnaces. | —0 |
Remove burned or damaged brick or mortar, using sledgehammer, crowbar, chipping gun, or chisel. | —0 |
Spray or spread refractory material over brickwork to protect against deterioration. | —0 |
Values in this tab are predicted labels, not observations. Eloundou et al. (2023) published two rating regimes — human raters and GPT-4 — and the β shown here is derived from the GPT-4 rater basis alone; the same task can take a different value under the other regime. The unit and the meaning differ from the observed shares (%) in the other tabs, so do not place them on the same axis.
| Task | βE1 + 0.5 × E2 |
|---|---|
Interpret blueprints and drawings to determine specifications and to calculate the materials required.O*NET Task ID 4774 | 0.5 |
Construct corners by fastening in plumb position a corner pole or building a corner pyramid of bricks, and filling in between the corners using a line from corner to corner to guide each course, or layer, of brick.O*NET Task ID 4768 | 0.0 |
Measure distance from reference points and mark guidelines to lay out work, using plumb bobs and levels.O*NET Task ID 4769 | 0.0 |
Calculate angles and courses and determine vertical and horizontal alignment of courses.O*NET Task ID 4770 | 0.0 |
Fasten or fuse brick or other building material to structure with wire clamps, anchor holes, torch, or cement.O*NET Task ID 4771 | 0.0 |
Break or cut bricks, tiles, or blocks to size, using trowel edge, hammer, or power saw.O*NET Task ID 4772 | 0.0 |
Remove excess mortar with trowels and hand tools, and finish mortar joints with jointing tools, for a sealed, uniform appearance.O*NET Task ID 4773 | 0.0 |
Apply and smooth mortar or other mixture over work surface.O*NET Task ID 4775 | 0.0 |
Mix specified amounts of sand, clay, dirt, or mortar powder with water to form refractory mixtures.O*NET Task ID 4776 | 0.0 |
Examine brickwork or structure to determine need for repair.O*NET Task ID 4777 | 0.0 |
Clean working surface to remove scale, dust, soot, or chips of brick and mortar, using broom, wire brush, or scraper.O*NET Task ID 4778 | 0.0 |
Lay and align bricks, blocks, or tiles to build or repair structures or high temperature equipment, such as cupola, kilns, ovens, or furnaces.O*NET Task ID 4779 | 0.0 |
Remove burned or damaged brick or mortar, using sledgehammer, crowbar, chipping gun, or chisel.O*NET Task ID 4780 | 0.0 |
Spray or spread refractory material over brickwork to protect against deterioration.O*NET Task ID 4781 | 0.0 |
β = E1 + 0.5 × E2 · E1 = tasks where direct LLM access alone cuts time by at least 50%, E2 = tasks where software built on top of an LLM cuts time by at least 50%. Values take only 0 / 0.5 / 1.0.
Data sources & licenses — O*NET®, Anthropic Economic Index, Eloundou et al. (2023): see full notices on the Credits page