عمال تركيب الأرضيات

البناء والصيانة والإصلاح

التعرّض للذكاء الاصطناعي

  • مصدر البيانات: BLSتاريخ النشر: 2026-08

    منخفض· نسبي

    منخفضأربع فئات نسبيةمرتفع جدًا

    قيمة على مستوى المجموعة المهنية

    المقياس والأساس والمصدر

    أربع فئات نسبية (منخفض / متوسط / مرتفع / مرتفع جدًا)

    831 مهنة تفصيلية في جدول توقعات التوظيف لدى BLS. وتُسند القيمة على مستوى رمز مصفوفة التوظيف الوطنية (NEM)، فالمهن التي تشترك في الرمز نفسه تأخذ النطاق نفسه

    مجموعة البيانات المصدر (تنزيل ملف XLSX)

  • مصدر البيانات: Anthropicتاريخ النشر: 2026-03

    0.000

    0.000نطاق القيم المعروضة هنا0.745
    المقياس والأساس والمصدر

    مؤشر التعرّض المرصود، 0–1 كما نُشر

    مربوط بمهام O*NET

    مجموعة البيانات المصدر

  • مصدر البيانات: ILOتاريخ النشر: 2025

    0.10

    0.09نطاق القيم المعروضة هنا0.70

    قيمة على مستوى المجموعة المهنية

    المقياس والأساس والمصدر

    مؤشر التعرّض للذكاء الاصطناعي التوليدي، 0–1 كما نُشر

    وحدة التصنيف ISCO-08 — تأخذ كل المهن ذات الرمز نفسه هذه القيمة

    محسوب من قِبل هذا الموقع وليس منشورًا من منظمة العمل الدولية: من بين 1,012 مهنة يربطها هذا الموقع بمجموعة بيانات المنظمة، تبلغ نسبة التي تساوي هذه القيمة أو تتجاوزها 98%.

    مجموعة البيانات المصدر

ما نوع القيمة التي ينشرها هذا المصدر

فئة BLS رتبة نسبية لا مستوى مطلق، وليست قياسًا مباشرًا: فهي تجمع الرتب المئينية للمهنة في عدة دراسات منشورة في أربع فئات. وهي ليست توقّعًا للتوظيف أو الأجور، ولا احتمالًا للتبني، ولا تفرّق بين الأتمتة والتعزيز.

Task-level exposure

Values in this tab are predicted labels, not observations. Eloundou et al. (2023) published two rating regimes — human raters and GPT-4 — and the β shown here is derived from the GPT-4 rater basis alone; the same task can take a different value under the other regime.

TaskβE1 + 0.5 × E2
Sweep, scrape, sand, or chip dirt and irregularities to clean base surfaces, correcting imperfections that may show through the covering.

O*NET Task ID 8253

0.0
Cut flooring material to fit around obstructions.

O*NET Task ID 8254

0.0
Inspect surface to be covered to ensure that it is firm and dry.

O*NET Task ID 8255

0.0
Trim excess covering materials, tack edges, and join sections of covering material to form tight joint.

O*NET Task ID 8256

0.0
Form a smooth foundation by stapling plywood or Masonite over the floor or by brushing waterproof compound onto surface and filling cracks with plaster, putty, or grout to seal pores.

O*NET Task ID 8257

0.0
Measure and mark guidelines on surfaces or foundations, using chalk lines and dividers.

O*NET Task ID 8258

0.0
Cut covering and foundation materials, according to blueprints and sketches.

O*NET Task ID 8259

0.0
Roll and press sheet wall and floor covering into cement base to smooth and finish surface, using hand roller.

O*NET Task ID 8260

0.0
Apply adhesive cement to floor or wall material to join and adhere foundation material.

O*NET Task ID 8261

0.0
Determine traffic areas and decide location of seams.

O*NET Task ID 8262

0.0
Lay out, position, and apply shock-absorbing, sound-deadening, or decorative coverings to floors, walls, and cabinets, following guidelines to keep courses straight and create designs.

O*NET Task ID 8263

0.0
Remove excess cement to clean finished surface.

O*NET Task ID 8264

0.0
Disconnect and remove appliances, light fixtures, and worn floor and wall covering from floors, walls, and cabinets.

O*NET Task ID 8265

0.0
Heat and soften floor covering materials to patch cracks or fit floor coverings around irregular surfaces, using blowtorch.

O*NET Task ID 8266

0.0

β = E1 + 0.5 × E2 · E1 = tasks where direct LLM access alone cuts time by at least 50%, E2 = tasks where software built on top of an LLM cuts time by at least 50%. Values take only 0 / 0.5 / 1.0.

Data sources & licenses — O*NET®, Eloundou et al. (2023): see full notices on the Credits page

معلومات مهنية